Table of Contents
Advertisement
Configuring firmware
3.4 "Advanced" tab
Key functions for setting the numeric time and date values
Key
<Enter>
[+] [-]
[0] - [9]
3.4
"Advanced" tab
3.4.1
"Boot Configuration"
Basic display and input options during the boot procedure
Calling "Boot Configuration"
Select: "Setup Utility (Page 10)" > "Advanced" > "Boot Configuration".
Firmware
Value
setting
Numlock
POST Errors
Never halt on
Halt on all errors
All without
keyboard
3.4.2
"Memory Configuration"
Configure the memory.
This configuration is only available for SIMATIC IPC BX-59A.
Calling "Memory Configuration"
Select: "Setup Utility (Page 10)" > "Advanced" > "Memory Configuration".
Firmware setting
ECC Support
12
Function
Switch between the setting options within a firmware setting, for example,
from hour to minute.
Increase or decrease desired value.
Enter desired value.
Setting in
delivery state
BX-56A BX-59A
Off
On
x
errors
x
Value
Setting in
delivery state
BX-59A
Enabled
x
Disabled
Numerical keypad is switched off after starting the device.
x
Numerical keypad is switched on after starting the device.
Continue the booting process when errors occur.
Cancel the booting process when any errors occur
x
Cancel the booting process if errors occur, except for keyboard
errors.
DDR ECC (Error Correction Code) Support is enabled.
DDR ECC Support is disabled.
Firmware/BIOS description (SIMATIC IPC BX-56A, IPC BX-59A)
Meaning
Meaning
Operating Instructions, 10/2023, A5E52427534-AA
Advertisement
Table of Contents
