Advanced Settings; Reset Amt With Unconfigure Me - Siemens SIMATIC Series Operating Instructions Manual

Technical specifications
8.7 Active Management Technology (AMT)
8.7.4

Advanced settings

The BIOS and the MEBx contain the most important basic settings for AMT. Additional tools
are necessary if you want to make more advanced settings. If required, these must be
downloaded from the relevant manufacturer's site. For information on the options and use of
these tools, refer to the relevant documentation of the manufacturer.
● Manageability Commander and other tools of the Intel DTK (Manageability Developer
Tool Kit): Programs from the Intel DTK that you can download from the Internet at
"http://software.intel.com/en-us/manageability".
● AMT Web interface: The URL of the Web interface is "http://<IP Address>:16993" for
encrypted connections and "http://<IP address>:16992" for unencrypted connections.
● WinRM: A command line program that is part of Windows as of Windows Vista. This tool
can be downloaded for older Windows versions.
8.7.5

Reset AMT with Unconfigure ME

Note
If the factory setting for the AMT PC was not changed, you can skip this chapter.
If you have already configured AMT previously, discard all previous AMT settings made in
the MEBx.
Note
Note the following points:
• All previous settings in the Management Engine are deleted.
• Correct operation in the plant may be at risk.
• Note down all the settings in the MEBx. Make the settings again as necessary following
Unconfigure.
The device continues booting in factory setting.
Procedure
1. Select the "Un-Configure AMT/ME" parameter in the "Advanced > AMT Configuration"
menu.
2. Exit BIOS with the key <F4>.
Your entry is saved and BIOS is closed. The AMT PC starts.
3. After the start, a user prompt appears asking whether you really want to discard all the
settings in the Management Engine.
4. Confirm with "Y". On a German keyboard, this means pressing the <Z> key.
168
Operating Instructions, 04/2020, A5E49948632-AA
SIMATIC IPC547G