Making Static Routes - Watchguard Firebox X15 User Manual

Changing Your Network Settings
To connect more than one computer to the optional interface, use a
10/100 BaseT Ethernet hub or switch with RJ-45 connectors. It is
not necessary for computers on the optional network to use the
same operating system.
To add more than one computer to the optional network:
1
Make sure that each computer has a functional Ethernet card.
2
Set each computer to use DHCP. For more information, see
"Setting Your Computer to Connect to the Edge" on page 22.
3
Connect each computer to the network. Use the procedure
"Connecting the Edge to more than seven devices" on page 20.
4
Restart each computer.

Making Static Routes

You can configure the Firebox® to send traffic to networks that are
behind routers on your trusted network when you add static routes
to these networks. Use the Routes page to make a static route:
1
To connect to the System Status page, type https:// in the
browser address bar, followed by the IP address of the Edge
trusted interface.
The default URL is: https://192.168.111.1
2
From the navigation bar, select Network > Routes.
The Routes page appears.
78 WatchGuard Firebox X Edge