Watchguard Firebox X15 User Manual page 232

Configuring the MUVPN Client
How do I map a network drive?
Because of a Windows operating system limitation, mapped network
drives must be mapped again when you work remotely. To map a
network drive again from the Windows desktop:
1
Right-click Network Neighborhood.
2 Select Map Network Drive.
The Map Network Drive window appears.
3
Use the drop-down list to select a drive letter.
Select a drive from the drop-down list or type a network drive path.
4 Click OK.
The mapped drive appears in the My Computer window. Even if you
select the Reconnect at Logon check box, the mapped drive appears
when you start your computer only if the computer is directly con-
nected to the network.
I am sometimes prompted for a password when I am
browsing the company network.
Because of a Windows networking limitation, remote user VPN
products can allow access only to a single network domain. If your
company has more than one network connected together, you can
only browse your own domain. If you try to connect to other
domains, a password prompt appears. Unfortunately, even if you
give the correct information, you cannot get access to these other
networks.
It takes a very long time to shut down the computer
after using the MUVPN client.
If you get access to a mapped network drive during an MUVPN ses-
sion, the Windows operating system does not shut down until it
gets a signal from the network.
I lost the connection to my ISP, and now I cannot use
the company network.
If your Internet connection is interrupted, the connection to the
MUVPN tunnel could stop. Follow the procedure to close the tunnel.
Reconnect to the Internet, then restart the MUVPN client.
218 WatchGuard Firebox X Edge