Watchguard Firebox X15 User Manual page 213

5
Type the path to the Windows NT installation files, or put your
system installation CD in the computer and click OK.
The Remote Access Setup window appears.
6 Click Yes to add a RAS device, and then click Add.
7
Complete the Install New Modem wizard.
If there is no modem installed, select the check box marked Don't
detect my modem; I will select it from a list. Select the standard
28800 modem. If a modem is not available, you can select a serial
cable between two computers.
8
Select the modem from the Add RAS Device window.
9 Click OK, click Continue, and click Close.
10 Restart the computer.
Configuring the WINS and DNS settings
The remote computer must be able to contact the WINS servers and
the DNS servers. These servers are found on the trusted network that
is protected by the Firebox X Edge.
From the Windows desktop:
1
Select Start > Settings > Control Panel.
2 Double-click the Network icon.
The Network window appears.
3
Click the Protocols tab and select the TCP/IP protocol.
4 Click Properties.
The Microsoft TCP/IP Properties window appears.
5
Click the DNS tab and click Add.
6 Type the IP address of your DNS server.
To add more DNS servers, repeat steps 5 and 6 for each server.
The DNS server on the private network of the Firebox X Edge must
be the first server in the list.
7
Click the WINS Address tab, type the IP address of your WINS
server in the applicable field, and then click OK.
You can also add a secondary or backup WINS server IP address.
8 Click Close to close the Network window.
The Network Settings Change dialog box appears.
User Guide
Preparing Remote Computers for MUVPN
N
OTE
N
OTE
199