Setup Menu Rules - Fluke 5730A Operator's Manual

5730A
Operators Manual
•
•
•

Setup Menu Rules

Each menu has a path shown at the top of the display that shows the current location in
the menu structure. This gives access to the menus used to get the present point. For
example, if Setup Menu is touched from the normal operation screen, the top of the
Setup Menu shows:
This type of symbol designates the top-level of the menu structure. For this manual, menu
paths are shown as in the subsequent example to reach the Remote Port menu:
Setup Menu>Instrument Setup>Remote Port
This example shows the path to this Remote Port section of the menu structure:
Setup Menu was the start point, then Instrument Setup was touched, and finally Remote
Port was touched to get to the Remote Port menu.
Conversely, from the Remote Port menu, touch Instrument Setup to go up one level,
Setup Menu to go up two levels.
An Exit or Cancel selection in the lower right of the display closes the menus or stops a
process. The 5730A Calibrator then returns to the normal operation screen.
4-46
Instrument Setup- Use this menu to:
• Choose and configure remote interfaces (see Chapter 5).
• Set parameters to compute output uncertainty.
• Impose limits on the Calibrator output for safety and external equipment
protection.
• Select boost amplifiers for voltage and current outputs.
• Enable or disable the ability to turn on or off ac transfers (real-time
measurements and adjustments of the value after the output is settled).
• Choose the error reference value (nominal or true value) used to compute unit
under test (UUT) errors.
The Instrument Setup submenu is explained in greater detail later in this chapter.
Instrument Settings- Use this menu to:
• Set the date and time as well as its format.
• Select the user interface language.
• Control the display brightness
The Instrument Settings menu is explained in greater detail later in this chapter.
About this Instrument- This shows hardware configuration and software version
information for the Calibrator. Nothing can be changed from this section.
Setup Menu