820-2
Users Manual
Setup Menu
When you push , the display shows the Setup menu. From the
Setup menu, you can change these parameters:
Hz setting – Adjust the flashes per seconds in Hz.
•
Pulse width in μs () – Adjust the flash intensity in
•
microseconds of pulse width.
Pulse width in degrees () – Adjust the flash intensity in
•
degrees of flash rate.
Delay in ms () – Adjust the delay time in milliseconds
•
between internal trigger and flash. Precise adjustments of the
observation position can be made with this setting.
Phase degree () – Adjust the degrees of phase shift
•
between internal trigger and flash. Precise adjustments of the
observation position can be made with this setting.
External trigger pulse divider () – Set the external trigger
•
divider, to adjust the flash rate.
External trigger edge () – Set the external trigger edge to
•
either positive (0) or negative (1).
Push , , and to make adjustments to each parameter.
Push to change parameters and to enter and exit the Setup
menu.
Range
When the external trigger is >5 kHz, -OL- shows on the display.
When the external trigger is <0.5 Hz, -UL- shows on the display.
10