Fluke 5730A Operator's Manual page 50

5730A
Operators Manual
8. Enter a frequency with the numeric keypad (followed by K if necessary). The
9. Push E. The Calibrator clears the entry from the entry bar near the bottom and
10. Push Pto activate the Calibrator output. The UUT will now respond to the
In AC current output, the selections available at the bottom are:
•
•
•
•
•
In addition, the Phase Control and Scale functions are available. The output range is
always automatically chosen and cannot be locked in ac current.
The Calibrator stays in the ac function after a non-zero frequency is
entered. To change back to dc, enter a frequency of 0 Hz or push + and
then E.
4-22
display now shows the amplitude and frequency of the entry. If an entry error is
made, push C to clear the display, then reenter the value. If the most recent digit
entered is in error, push B to clear that digit. The display below assumes an entry of
2.5 kHz:
shows in the larger area above. No current is available at the output terminals until
P is pushed.
applied current.
Current Output
External Guard
Boost
Wideband
Setup Menu
Note
hhp120.tif