Flat Surface Installation; Unpacking The Power Supplies; Securing The Ssa Switch To The Rack In A Mid-Mount Configuration - Enterasys S Series Hardware Installation Manual

Figure 2-8
1 4–6 screws or fasteners appropriate to the rack
You can now install the SSA power supplies. See

Flat Surface Installation

For flat surface installation, optionally attach the adhesive rubber feet to the bottom of the SSA
switch.
To attach the rubber feet to the bottom of the SSA switch:
1. Place the SSA switch upside down on a sturdy, flat surface.
2. Remove the adhesive backing from the four rubber feet.
3. Adhere the rubber feet to the round, recessed areas on the bottom of the SSA switch.
You can now install the SSA power supplies. See

Unpacking the Power Supplies

The SSA-FB-AC-PS-A and SSA-FB-AC-PS-B power supply modules are shipped in boxes separate
from the SSA switch. To unpack a power supply:
1. Remove the power supply from the shipping box and slide the two foam end caps off the unit.
Save the shipping box and materials in the event the unit must be reshipped.
2. Verify the contents of the box using
3. Remove the power supply from its protective plastic bag.
4. Examine the power supply carefully, checking for damage.
If there are any signs of damage, DO NOT install the power supply; instead, contact Enterasys
Networks. Refer to

Securing the SSA Switch to the Rack in a Mid-Mount Configuration

"Getting Help"
"Installing the Power
"Installing the Power
Table 2-4.
on page xviii for details.
Enterasys S-Series Stand Alone (SSA) Hardware Installation Guide 2-11

Unpacking the Power Supplies

Supplies" on page 2-12.
Supplies" on page 2-12.