Error Messages On The Lcd Display - Panasonic KX-FMC230 Operating Instructions Manual

Error messages on the LCD display
If the unit detects a problem, one or more of the following messages will appear on the display.
DISPLAY MESSAGE
I CALL SERVICE i
[ CHECK COVER I
I CHECK FILM
1
I CHECK LEVER L
I CHECK MEMORY I
[ CHECK PAPER I
FAX IN
MEMORY
[
I FILM EMPTY I
[ FILM NEAR EMPTY I
IMEMORY FULL I
INO RESPONSE
I
LFAPER I
IFc FAIL O R BOSY I
CAUSE&REMEDY
oThere is something wrong with the unit. Contact our service personnel (p. 122).
oThe front cover is open, Close it.
oThe document is not fed into the unit properly. Reinsert the document. If
misfeeding occurs frequently, clean the document feeder rollers inside the unit
(p. 114). If the problem remains, adjust the feeder pressure (p. 109).
oThe film cartridge is not inserted properly. Reinsert it correctly (p. 110, 111).
oThe recording paper set lever is released. Push the lever back to reset (p. 20).
oMemory (phone numbers, parameters, etc.) has been erased. Re-program.
oThe recording paper is not installed or the unit ran out of paper. Install paper
(p. 20).
oThe recording paper is not fed into the unit properly or has jammed near the
recording paper entrance• Clear the jammed paper (see "When paper has
jammed near the recording paper entrance" on page 108).
Do not install folded or heavily curled paper in the paper tray.
oThe unit has (a) document(s) in memory. See the other message's instructions to
print out the document(s).
oThe film is empty. Replace the film or film cartridge with a new one (p. 110, 111).
,,The film is slack. Tighten it (see step 8 on page 111 ) and install again.
oThe remaining film can print approx. 15 pages of letter size documents. Prepare a
new film or film cartridge (p. 7).
oThe memory is full of received documents due to a lack of recording paper or a
recording paper jam, etc. Install paper or clear the jammed paper.
oWhen performing memory or multistation transmission, the document being stored
exceeds the memory capacity of the unit. Transmit the entire document by using
manual or automatic transmission.
,,The receiving unit is busy or ran out of recording paper. Try again•
eA recording paper is jammed under the film cartridge. Clear the jammed paper
(p. 107).
,,The fax function cannot be operated by the PC. The RS232C cable is not
connected correctly, or the software is not running on the PC.
96 l
For Assistance, Call 1-800-435-7329 I