Error Messages On The Display - Panasonic KX-F1600 Operating Instructions Manual

Error messages on the display
If the unit detects a problem, one of the following messages will appear on the display
ERROR MESSAGE CAUSE & REMEDY
oA document is received in memory when the unit ran out of recording paper
AD pels nn
Install paper (see page 14), and then press the START/SET button
oThe unit cannot control the cartridge or temperature sensor on the unit Is
abnormal Leave the unit for approx 15 minutes and then press the START/SET
button
CHECK CARTRIDGE
o The document is not fed into the unit properly Reinsert the document and try
again If misfeeding occurs frequently, clean the feeder rollers (see page 73) If
the problem remains, adjust the feeder pressure (see page 66)
CHECK DOCUMENT
oMemory (phone numbers, parameters, etc ) has been erased
CHECK MEMORY
Re-program
INK EMPTY oThe print cartridge ran out of ink during fax reception. Replace the cartridge
INSTALL INE oThe print cartridge is not installed properly Install it correctly (see page 10)
oWhen transmitting a document from memory, the document to be stored
exceeds the memory capacity of the unit. Turn off the memory transmission
feature or transmit the entire document manually
oThe memory is full of received documents that have been stored in memory due
to a lack of recording paper, a recording paper jam and so on Install paper or
clear the jammed paper
MEMORY FULL
o receiving unit w or ran out of recording paper Try again Ro eee The g as busy ording pap ry ag
oThe temperature sensor in the print head of the print cartridge exceeds the
prescribed level or is abnormal Leave the unit for approx. 15 minutes and press
the START/SET button to resume operation
OVERHEATED
PAPER JAMMED OA recording paper jam occurred Remove the jammed paper (see page 65)
oThe front lid is opened or closed, the printer mode is turned on or off, or a printer
EASE WAIT
PHASE error is reset Wait for a while
oThe other fax machine does not provide the polling function. Check the other
party
oPrinter error occurred Leave the unit for approx 15 minutes and then press the
START/SET button to resume operation
POLLING ERROR
PRINTER ERROR
oThe document is jammed Remove the jammed document (see page 66)
oAttempted to transmit a document longer than 600 mm (23%") Press the STOP
button and remove the document (see page 66) Divide it into two or more
sheets and try again
REMOVE DOCUMENT
o
TRANSMIT ERROR Transmission error occurred Try again
oWhen the unit is in the printer mode, the fax documents sent by the other party
are stored in memory To print them, turn the printer mode off
WAITING PRINT
61