Signaling Your Pager When You Receive A Fax - Panasonic KX-FMC230 Operating Instructions Manual

Signaling your pager when you receive a fax -----
This feature allows your unit to call your pager when your unit receives a fax message.
Press (_.
Display: I
SYSTEM SET UP i
2
Press [_, then [] [_.
] F_ PAGER I
Press {START/COPY/SET}.
{MODE=OFF [TA] i
4 Press @ or (_) to select "ON".
LMODE=ON
[VA]J
elf this feature is not required, select "OFF".
Press [START/COPY/SET}.
NO.=
Enter your pager number.
• If this feature does not work properly, press
CREDIAL/PAUSE} more than once at the end of
your telephone number to extend the paging
time.
If you wish to display a message on your pager,
enter the message after your pager number and
pause(s).
Programming methods may vary depending on
the pager company. Contact your pager company
for details,
• You can enter _-total of 46 digits and/or pauses.
Press [START/COPY/SET}.
SETUP ITEM [ ]
Press _.
Dial keypad
[REDIAL/PAUSE_
[START/COPY/SET
Note:
eThis feature is not available when the receive mode is
set to the TEL mode.
75