Mitsubishi Electric MELSEC iQ-R C Series Programming Manual page 232

Error code
Decimal Hexadec
imal
-234 FF16H
-235 FF15H
-236 FF14H
-237 FF13H
-238 FF12H
-239 FF11H
-240 FF10H
-241 FF0FH
-242 FF0EH
-245 FF0BH
-246 FF0AH
-247 FF09H
-248 FF08H
-249 FF07H
-250 FF06H
-252 FF04H
-253 FF03H
-254 FF02H
-255 FF01H
230
Description
Event wait error
An error other than timeout occurred while the function waits
for the event.
Number of event settings specification error
The specified number of event settings is out of range.
Remote operation specification code error
The remote operation specification code is out of range.
Detailed information character string specification error
The length of the specified character string was out of range
or characters which cannot be specified was specified.
Application code specification error
Five or more digits of the hexadecimal number was
specified for the application code.
Event log registration error
Registering an event log failed.
Drive insertion error
Either of the following functions executed with no drive
inserted.
• CCPU_UnmountMemoryCard
• CCPU_MountMemoryCard
Clock data incorrect error
The clock data to be set or the read clock data is incorrect.
Cycle specification error
• The specified cycle is out of range.
• The cycle was set even when it had already been set.
Synchronization type specification error
The specified synchronization type is out of range.
Not executable during interrupt service routine
A function was executed from interrupt service routine
without specifying '1' (ISR) to the call source flag.
Timer event registration error
Registering a timer event failed.
Program number specification error
The specified program number is out of range or
unavailable.
• SFC program number (0 to 255)
• Servo program number (0 to 4095)
Number of starting axes specification error
9 or more starting axes were specified.
Axis type specification error
An axis type other than the axis/encoder axis/cam axis was
specified.
Axis number specification error
The specified axis number is out of the available range.
Torque limit value specification error
The specified torque limit value is out of the available range.
Device number specification error
• The specified device number is out of range.
• The specified bit device number is not a multiple of 16.
Device type specification error
The specified device type is unavailable.
Size specification error
• The specified number of words is out of range.
• The specified size is 0.
• The sum of values for specified module label, offset, and
data size exceeds the range of module label (label
memory).
Corrective action
• Check if a program is forcibly being terminated.
• Check if the C Controller module is running normally.
• Reset the C Controller module, or turn the power OFF and ON.
Check the number of specified event settings.
Check the specified remote operation specification code.
Correct the length of the specified character string or character
string data.
Change the specified application code.
Reset the C Controller module, or turn the power OFF and ON.
Check if a drive is inserted.
• Check the clock data to be set.
• If this error occurs when reading the clock data, set the data
again.
• Check the specified cycle.
• Check if the cycle has been already set.
Check the specified synchronization type.
Specify '1' to the call source flag (ISR) and execute the function
again.
• Retry.
• Check if the C Controller module is running normally.
• Reset the C Controller module, or turn the power OFF and ON.
Correct the specified program number.
Correct the specified number of starting axes.
Correct the specified axis type.
Correct the specified axis number.
Correct the specified torque limit value.
Correct the start device number of the specified device.
Check the specified device type.
• Correct the specified start device number and number of words.
• Correct the module label, offset and data size specified in the user
program.