Attaching And Removing The Attachment Tool - Parkside PPFBSA 12 A1 Translation Of The Original Instructions

GB MT
Function
Milling
Attaching and removing the
attachment tool
Notes
• The maximum diameter of assembled
grinding wheels and of grinding cones
and mounted points with threaded in-
serts must not exceed 55 mm.
The maximum diameter of sandpaper
grinding accessories must not exceed
80 mm.
• Mount the following attachment tools
on the corresponding mandrel before
use:
• Cutting disc (29), Cutting disc
(small) (34): Mandrel (cutting disc)
(24)
• Grinding disc (35), Sandpaper
(36): Mandrel (grinding disc) (24)
• Grinding belt (40): Mandrel (abras-
ive belt) (39)
• Felt polishing disc (large) (32), Felt
polishing disc (small) (33): Mandrel
(polishing disc) (23)
• The mounting key (42) serves as a
spanner for the clamping nut (1) and
as a screwdriver for the mandrels for
cutting and grinding discs (24).
• Note the protrusion a indicated for
each attachment tool.
• Risk of damage! Never tighten the
clamping nut if no attachment tool is in-
serted in the collet.
Requirements
• Battery removed.
40
Attachment tool
Milling pin (25)
Spiral milling pin (27)
Milling cutter pin
(26)
Speed
level* ≤ Use
6 Machining wood,
plastic and soft
6
metals such as alu-
6
minium, copper and
brass
Mounting cutting discs on the
mandrel
1. Loosen the screw on the mandrel for
cutting discs (24).
2. Guide the screw through the hole of
the cutting disc (29, 34).
3. Reattach the screw to the mandrel for
cutting discs (24).
NOTICE! Breaking the disc. Tighten
the screw by hand only.
Mounting grinding discs/sandpa-
per on the mandrel
1. Loosen the screw on the mandrel for
grinding discs (24).
2. Guide the screw through the hole of
the desired disc (35, 36).
3. Reattach the screw to the mandrel for
grinding discs (24).
Mounting a grinding belt on the
mandrel
1. Slide the grinding belt (40) onto the
mandrel (39).
2. Pull a worn abrasive belt (40) back off
the mandrel (39).
Mounting a polishing disc on the
mandrel
1. Put the centring hole of the polishing
disc (32, 33) on the mandrel (23).
2. Tighten the polishing disc (32, 33) on
the mandrel (23).
Procedure (Fig. A)
1. Press and hold the spindle lock (4).
2. Loosen the clamping nut (1).
You can release the spindle lock (4).
Protru-
sion a
[mm]
20
20
20