Safety Warnings Specific For Wire Brushing Operations; Residual Risks - Parkside PPFBSA 12 A1 Translation Of The Original Instructions

the wheel comes to a complete
stop. Never attempt to remove
the cut-off wheel from the cut
while the wheel is in motion
otherwise kickback may occur.
Investigate and take corrective action
to eliminate the cause of wheel pinch-
ing or snagging.
• Do not restart the cutting op-
eration in the workpiece. Let
the wheel reach full speed and
carefully re-enter the cut. The
wheel may bind, walk up or kickback if
the power tool is restarted in the work-
piece.
• Support panels or any over-
sized workpiece to minimize
the risk of wheel pinching and
kickback. Large workpieces tend to
sag under their own weight. Supports
must be placed under the workpiece
near the line of cut and near the edge
of the workpiece on both sides of the
wheel.
• Use extra caution when mak-
ing a "pocket cut" into existing
walls or other blind areas. The
protruding wheel may cut gas or water
pipes, electrical wiring or objects that
can cause kickback.
Safety Warnings Specific For
Wire Brushing Operations
• Be aware that wire bristles are
thrown by the brush even dur-
ing ordinary operation. Do not
overstress the wires by apply-
ing excessive load to the brush.
The wire bristles can easily penetrate
light clothing and/or skin.
• Allow brushes to run at oper-
ating speed for at least one
minute before using them.
During this time no one is to
stand in front or in line with the
brush. Loose bristles or wires will be
discharged during the run-in time.
• Direct the discharge of the spin-
ning wire brush away from
you. Small particles and tiny wire frag-
ments may be discharged at high velo-
city during the use of these brushes and
may become imbedded in your skin.

Residual risks

There will always be residual risks even
if you operate this power tool according
to the instructions. The following hazards
may occur in connection with the type and
design of this power tool:
• Lung damage if suitable respiratory
protection is not worn.
• Hearing damage if suitable ear protec-
tion is not worn.
• Health injuries resulting from the effect
of vibration on the hands and arms in
the event that the device is used over
a longer period of time or is not used
and maintained properly.
• Damage to health as a result of:
• touching the area of the grinding
tool which is not covered;
• ejection of parts of workpieces or
damaged grinding discs.
WARNING! Danger due to electro-
magnetic field generated while the ma-
chine is in operation. Under certain cir-
cumstances, this field may negatively af-
fect active or passive medical implants.
In order to reduce the danger of serious
or fatal injuries, we recommend that indi-
viduals who wear medical implants should
consult their doctor and the manufacturer
of the implant before operating the ma-
chine.
GB MT
37