Kit Edit / Eq - Korg MPS-10 Owner's Manual

MPS-10
- Parameter guide
PAD Exchange ........................................................................................... On, Off
Enables/disables PAD Exchange.
Note: You can still use the "Control Param" function even if "PAD Exchange" is enabled.
PAD1.................................................................. PAD1...PAD10 / A,B,C,D / Pedal
PAD2................................................................. PAD1...PAD10 / A,B,C,D / Pedal
Selects the pad that switches when you operate the pedal.
Polarity ..............................................................................................................-, +
Changes the expression pedal direction in which PAD 1 switches with PAD 2.
Position ......................................................................................................... 1...99
Adjusts the pedal position in which PAD 1 switches with PAD 2.
Note: The pad in question is shown in dark gray when "PAD Exchange" is configured on the foot switch side. To
avoid duplicating the PAD Exchange settings for a pad, you cannot select a pad shown in dark gray.

KIT EDIT / EQ

This adjusts the EQ (equalizer) parameters for the currently selected KIT, which lets you calibrate the
sound quality or make more aggressive changes to the sound.
You can make EQ settings separately for the Main, IFX1 and IFX2.
Use the METRONOME knob to switch between "to Main", "to IFX1" and "to IFX2". (All three effects use
the same parameters.)
EQ On/Off ................................................................................................... On, Off
Enables/disables the EQ effect.
Input Trim................................................................................................ 0...100%
Adjusts the input level going into the EQ. The sound may distort when using certain EQ settings.
If this happens, use this parameter to adjust the level so as to avoid distortion.
Output Level .......................................................................................... 0...200%
Adjusts the EQ output level. As the output volume may change depending on the EQ settings, use this
parameter to adjust the volume as appropriate.
Low Freq ....................................................................................... 60Hz...15.4kHz
Sets the frequency band for which the low end EQ is adjusted.
Low Gain ........................................................................................-18dB ... +18dB
Boosts or cuts the low-end EQ frequency band (in 0.5 dB units).
Mid Freq ........................................................................................ 60Hz...15.4kHz
Sets the specific frequency band at which the EQ is adjusted.
Mid Gain.........................................................................................-18dB ... +18dB
Adjusts specific EQ frequency bands upwards or downwards (in 0.5 dB units).
50