Table of Contents
Advertisement
MPS-10
- Editing the KITs
To switch between categories, press the EDIT button on the SAMPLE SELECT page.
This shows the SAMPLE CATEGORY SELECT page as shown above. Turn the VALUE knob to select a
new category, and press the ENTER button.
To close the sub-window without changing the category, press the EXIT button.
Once you change the category, the SAMPLEs for the new category are shown.
Move the cursor to the SAMPLE you want to select and press the ENTER button to finish selecting the
SAMPLE file.
Tip: When the SAMPLE SELECT page is shown, the Track 1–4 buttons serve as transport keys. This lets you check
the SAMPLE files. When you check the SAMPLE files, be careful that the headphone volume is not set too high,
as the SAMPLE volume may be loud.
See "Editing SAMPLE data" on page 41 for more information on editing the SAMPLEs.
Saving an INST
To save the INST settings you've edited, you must write them to memory.
1
On the INST EDIT screen, press the WRITE button. The INST WRITE page appears as shown
below.
Note: You can write the data to memory from any page in INST Mode.
2
With "Name" selected, press the ENTER button to show the INST name edit screen. ( p. 24,
"Using the Name dialog box (how to change the name)")
28
Advertisement
Table of Contents
