Adjusting The Clip Rate; Adjusting The Reel Speed; Adjusting The Traction-Drum Position - Toro Greensmaster e1021 Operator's Manual

Adjusting the Clip Rate

The clip rate is determined by the following machine
settings:
•
Reel speed: You can adjust the reel speed to a
high or low setting; refer to
Speed (page 14).
•
Reel-drive-pulley position: You can set the
reel-drive pulleys in 2 positions; refer to your
cutting unit Operator's Manual.
To determine the reel speed and reel-drive-pulley
position for the appropriate clip, refer to the following
table:
Clip Rate
Reel Belt
Speed Position
8-blade
Low Low 7.3 mm
(0.286 inch)
Low High 8.7 mm
(0.241 inch)
High Low 5.9 mm
(0.233 inch)
High High 5.0 mm
(0.196 inch)

Adjusting the Reel Speed

Use the reel-speed-control knob
the reel speed.
•
High reel speed: Rotate the knob so that the "H"
on the knob is directed toward the front of the
machine.
•
Low reel speed: Rotate the knob so that the "L"
on the knob is directed toward the front of the
machine.
Adjusting the Reel
Cutting Unit
11-blade 14-blade
5.3 mm 4.2 mm
(0.208 inch) (0.164 inch)
4.4 mm 3.5 mm
(0.175 inch) (0.137 inch)
4.3 mm 3.4 mm
(0.169 inch) (0.133 inch)
3.6 mm 2.8 mm
(0.142 inch) (0.112 inch)
(Figure 15) to adjust
1. Reel-speed-control knob (shown in the high-reel-speed
position)
Adjusting the
Traction-Drum Position
The traction drum can be adjusted to 2 positions:
•
L position: Use this position for mowing at a
OW
lower height of cut (e.g., mowing a golf-course
green).
•
H position: Use this position for mowing at a
IGH
higher height of cut (e.g., mowing a golf-course
tee box).
1. Move the kickstand to the C
position; refer to
2. Remove the shoulder bolts
side of the machine that secure the drum drive
housing to the chassis.
14
Figure 15
-U
UTTING NIT
Kickstand (page 11).
(Figure 16) on each
g341648
S
ERVICE