Selecting Clip Rate (Reel Speed) - Toro REELMASTER 6700-D Operator's Manual

approximate ranges of traction speed which will result in the
desired clip are as follows for several of the possible heights of
cut:
* Procedure for maintaining proper clip rate:
1. Set HOC selector knob to correct letter setting (Per chart located under seat plate).
2. Maintain ground speed which prevents reel control light from illuminating

SELECTING CLIP RATE (REEL SPEED)

To achieve a consistent, high quality of cut, and a uniform after-
cut appearance, the reel speed be matched to the height of cut.
The machine controller is programmed to automatically control
the reel speed to give the correct clip, even as traction speed
changes. To control the reel speed, the controller must know
the height of cut of the machine, and whether the machine is
equipped with 5-, 7-or 11-blade reels.
Adjust the height-of-cut selector knob as follows:
1. Verify the height-of-cut setting on the cutting units. Using
the column of the chart above or the chart under the seat
plate, listing either 5-, 7- or 11-blade reels, find the height
of cut listing nearest the actual height-of-cut setting. Look
across the chart to find the letter corresponding to that
height of cut.
2. Turn the height-of-cut selector knob to the letter setting
Figure 17
1. Height-of-cut selector knob
19