Installing The Transport Wheel Shafts (For Gr1000 And Gr1600); Installing The Transport Wheels (Optional) - Toro 04054 Operator's Manual

1. Kick stand
2. Spring bracket
3. Mount the kick stand to each side of the frame with
a bolt, lockwasher, spacer, flat washer and locknut
(Figure 6). Position the spacer in the kick stand
mounting hole.
3
Installing the Transport Wheel
Shafts (For GR1000 and
GR1600)
Parts needed for this procedure:
1 Wheel shaft, right
1 Wheel shaft, left
Procedure
1. Push the kick stand down with your foot and pull up
on the handle to support the mower on the kick stand.
2. Apply #242 Loctite to the threads of the wheel shafts.
3. Thread the right wheel shaft into the drive pulley on
the right side of the machine (Figure 7).
Note: The right wheel shaft has left hand threads.
Figure 6
3. Spring stud
4. Spring
1. Right wheel shaft
4. Torque the shaft to 65 to 75 ft-lb (88 to 101 N-m).
5. Repeat on the left side.
4
Installing the Transport
Wheels (Optional)
Parts needed for this procedure:
2 Transport wheels (optional)
Procedure
1. Slide the wheel onto the axle (Figure 8).
2. Pivot the wheel locking clip away from center of
the wheel allowing it to slide farther onto the axle
(Figure 8).
11
Figure 7