Installing The Transport-Wheel Shafts - Toro Greensmaster 1000 Operator's Manual

Figure 5
1. Cable ties
Adjusting the Handle
Refer to Figure 6
g017590
1. Handle
2. Hairpin cotter
1. Remove the hairpin cotters from the ring pins on
each side of the machine.
2. While supporting the handle, remove the ring
pins from each side and raise or lower the
handle to the desired operating position.
3. Install the ring pins and hairpin cotters.
2
Installing the
Transport-Wheel Shafts
Parts needed for this procedure:
1 Right wheel shaft
1 Left wheel shaft
Procedure
1. Push the kickstand down with your foot and pull
up on the handle to support the machine on the
kickstand.
2. Apply thread-locking adhesive to the threads of
the wheel shafts.
9
for this procedure.
Figure 6
3. Ring pin
g240512