Installing Your Ups System; System Block Diagram; Hardware Installation Guide - CyberPower OLS6KERT4UA Installation And Operation Manual

Table of Contents

Advertisement

SYSTEM BLOCK DIAGRAM

Input
Input
Filter
Charger
AC/DC
Line Mode
Battery Mode
Bypass Mode
Control Signal

HARDWARE INSTALLATION GUIDE

1 . Battery charge loss may occur during shipping and storage. Before using the UPS,
it's strongly recommended to charge batteries for four hours to ensure the batteries'
maximum charge capacity. To recharge the batteries, simply connect the UPS to its
designated AC electrical service.
2 . When using PowerPanel Business software, connect either the serial or the USB cable
between the computer and the corresponding port on the UPS. After connecting to
either the USB port or the serial port on the UPS, a computer with PowerPanel Business
Agent software installed can control the operating schedule, battery test, outlets, as well
as obtain UPS status information. However, other computers with PowerPanel Business
Client software can only obtain UPS status information via LAN connection.
3 . Connect your computer, monitor, and any externally-powered data storage device (Hard
drive, Tape drive, etc.) into the outlets only when the UPS is off and unplugged. DO NOT
plug a laser printer, copier, space heater, vacuum, paper shredder or other large electrical
device into the UPS. The power demands of these devices will overload and possibly
damage the unit.
4 . Press the ON/OFF switch to turn the UPS on. The Power-On indicator LED will turn on
when activated. If an overload is detected, an audible alarm will sound and the UPS will
continuously emit two beeps per second. For resetting the unit, unplug some equipment
from the outlets. Make sure your equipment carries a load current within the unit's safe
range, (refer to the technical specifications).
5 . This UPS is equipped with an auto-charge feature. When the UPS is connected to AC
electrical service the battery will automatically charge, even when the unit is switched off.

INSTALLING YOUR UPS SYSTEM

BYPASS
PFC
BUS
AC/DC
Battery
Inverter
INV
DC/AC
RLY
LCD
Module
Control
&
USB&DB9
Monitoring
SNMP
Slot
10
Output
Output
Filter

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ols10kert4uaOls6kert5uOls10kert5u

Table of Contents