Table of Contents
Advertisement
INSTALLING YOUR UPS SYSTEM
UNPACKING
Inspect the UPS upon receipt.
The box should contain the following:
(a) UPS unit
(b) User's manual
(c) USB A+B type cable
(d) Function Setup Guide
PowerPanel® Personal software is available
on our website. Please visit www.cyberpower-
systems.com and go to the Software Section
for a free download.
OVERVIEW
The CP850/1000/1350/1500AVRLCD provides
complete power protection from utility power
that is not always consistent.
The CP850/1000AVRLCD features 1080 Joules
and the CP1350/1500AVRLCD features 1500
Joules of surge protection.
The unit provides long lasting battery backup
during power outages with maintenance free
batteries.
The CP850/1000/1350/1500AVRLCD ensures
consistent power to your computer system
and includes software that will automatically
shut down your computer system during a
utility power loss.
AUTOMATIC VOLTAGE REGULATOR
The CP850/1000/1350/1500AVRLCD stabiliz-
es inconsistent utility power to nominal levels
that are safe for equipment. Unstable utility
power can be damaging to important data and
hardware. With Automatic
Voltage Regulation (AVR),
damaging voltage levels
are corrected to safe
levels. AVR automatically
increases low utility power
to a consistent and safe
110/120 volts.
DETERMINE THE POWER
REQUIREMENTS OF YOUR EQUIPMENT
1. Ensure that the equipment plugged into
the UPS does not exceed the UPS unit's
rated capacity. If the rated capacities of the
unit are exceeded, an overload condition
may occur and cause the UPS unit to shut
down or the circuit breaker to trip.
2. There are many factors that can affect
the amount of power that your electronic
equipment will require. For optimal system
performance keep the load below 80% of
the unit's rated capacity.
HARDWARE INSTALLATION GUIDE
1. Your new UPS may be used immediately
upon receipt. However, after receiving a
new UPS, to ensure the battery's maximum
charge capacity, it is recommended that
you charge the battery for at least 8 hours.
Your UPS is e quipped with an auto charge
feature. When the UPS is plugged into an
AC outlet, the battery will automatically
charge whether the UPS is turned on or
turned off.
Note: This UPS is designed with a safety
feature to keep the system from being turned
on during shipment. The first time you turn
the UPS on, you will need to have it connect-
ed to AC power or it will not power up.
2. With the UPS unit turned off and unplugged,
connect your computer, monitor, and any
other peripherals requiring battery backup
into the battery power supplied outlets. Plug
the other peripheral equipment (eg. printer,
scanner, speakers, etc.) into the full time
surge protection outlets.
DO NOT plug a laser printer, paper shredder,
copier, space heater, vacuum cleaner, sump
pump or other large electrical device into
the "Battery and Surge Protected Outlets".
The power demands of these devices will
overload and possibly damage the unit.
3. Plug the UPS into a 2 pole, 3 wire grounded
receptacle (wall outlet). Make sure the wall
branch outlet is protected by a fuse
or circuit breaker and does not service
equipment with large electrical demands
(e.g. air conditioner, refrigerator, copier,
etc.). The warranty prohibits the use of
– continued
Advertisement
Table of Contents
