13.CROSSOVER FREQUENCY SETTING
(D Press the "F/C" display key.
The LCD will display the graphical display for the
crossover
frequencies
and the cutoff
status.
In this display,
the cutoff
points are 500 and 2 kHz, both
those keys are
therefore
152
at this
time.
Example
j
(©) Press one of the "4K, 2K, ог ІК" keys (see SECTION
Ш).
Те LED in the center of the
key will
light up,
and the mid-low and mid-high
band crossover
frequencies
will be
set.
The LCD display will also change accordingly.
© Press one of the "500, 250, or 125" keys (see SECTION
Ш).
The LED in the center of
the key will
light up,
and the low and mid-low band crossover
frequencies
will be
set.
The LCD display will also change accordingly.
14.REVERBERATION TIME ADJUSTMENT BY FREQUENCY BAND
The mid-low band value set in (6) will be the standard value,
and in this operation
the
reverberation
time for the other
three bands will be altered.
@ Press either the "R/T" or the "RATIO" display key.
The LCD will show the
relationship
between
the different
bands of reverberation
time.
Diaplay:
Ratio Mode
РЕШ.
TIME
RATIO
@ Use the "LOW" selector
to alter
the low reverberation
time band.
The LCD will change
according
to the setting of the selector.
@ Use the "MID-HI" selector
to alter the mid-high reverberation
time band.
The LCD
will
change according
to the setting of the selector.
@ Use the "HIGH" selector
to alter the high reverberation
time band.
The LCD will
change according
to the setting of the selector
29