Advertisement
4.SETTING METHOD SELECTION
A. Reading Pre-set Key Data
(D First,
see SECTION
IV for information
about
the pre-set
keys
(1 to 8) of the remote
control
unit.
Press
the desired
"PRESET"
key,
to set the data.
A display such as
the one below will
come on the LCD for 1 or 2 seconds.
This shows
that the data displayed
is pre-set.
In this case,
the data
shown
is the same as the data in
memory
1.
Example
MEMORY
LARGE
HALL
Data Title
After 1 or 2 seconds,
the display will change to the graphical
type (depending on
the selection with the "DISPLAY" keys), and the data will be set.
@ To alter
the pre-set data,
press
the "EDIT" key,
and see
the next operation
example.
B. Reading Memory Data
(D Press the "M" memory key (see SECTION IV).
@ Use the ten-key numerical
pad to specify
the number of the desired memory.
The memory number will blink on the LCD (see the "Memory List" on page 11).
(9 Press
the "RECALL"
memory
key,
and the contents
of the memory
will be displayed
on
the LCD.
The contents
of the memory will now have been set.
C. Creating New Data
(D Press the "P" panel key (see SECTION IV), new data can now be entered at will with
the various
controls
of the remote control
unit.
Or:
@ Press the "AUTO" panel key.
The LED in the center of the key will light up, and all
parameters will an "AUTO" key will be set to a standard value.
Press it one more
time,
and bring the unit out of auto mode;
or:
(9 To break out of auto mode for each parameter
separately,
and set manually,
press each
key separately.
When pressed,
the LED of the key will
turn off.
25
Advertisement
