Advertisement
(9 E/R NUMBER (Early Reflection Selector)
This selector
has eight settings
in a range
from ] to 40.
To change
the E/R number,
first press
the
"EDIT" key in the upper right hand corner of
the panel,
and then adjust
the E/R selector
until
the LED in the center of the E/R indi-
cator above
the selector
lights.
Then,
the
setting can be changed
if desired.
(б LIVENESS
Indicator
This
is the set of three LEDs above
the
"LIVENESS " selector.
It is used to indicate
if the liveness
value read from a memory
is
larger
than,
smaller
than,
or equal
to the
current
setting of the "LIVENESS"
selector
underneath
it.
@ LIVENESS Selector
Sound absorption
(attenuation)
can be adjust-
ed within a range of eight settings
(1 to 8).
The closer to "8", the more "live"
the sound
output will be, and the closer to 41", the
more "dead" the sound output will be.
To change
the liveness
setting,
first press
the "EDIT" key in the upper right hand corner
of the panel,
and then adjust
the control
until
the LED in the center of the liveness
indicator
above
lights.
Then,
the liveness
value can be changed
if desired.
The Liveness AUTO key
To use this key, first press
the "P" key in
the upper right hand corner
of the panel.
Then press
the key,
and the LED in the center
will
light.
At this time,
the liveness
value
becomes automatically
controlled,
and is set
to a standard
value which
is calculated
ac-
cording
to the reverberation
time.
@ E/R DELAY (D]) Display
This is a 3-digit LED indicator.
It displays
the difference
in time between
the direct
sound and the arrival
of the first early
reflection.
The early reflection
delay
time
сап be set from 0 to 600 msec in steps of 1
msec.
00 E/R Delay AUTO Key
When
this key is lit,
the early reflection
delay
time will
be controlled
automatically
and will
be set to a standard
value which
is
calculated
according
to the E/R mode and the
"ROOM SIZE".
To operate,
first press
the "P"
key in the upper right hand corner of the
panel,
then press
this key.
(D E/R Level AUTO Key
When
this key is lit,
the early refrection
level
is controlled
automatically,
and set to
the maximum level.
Press the "P" key in the
upper right hand corner
of the panel
before
using
this key.
(2 EARLY REFLECTION ON Key
Press the "EDIT" key in the upper right hand
corner
of the panel before using this key.
When
lit,
early reflections
are sent
to the
output;
when pressed again,
the LED goes out,
and early reflections
are removed
from the
output.
@ E/R Level Indicator
This is the set of three LEDs above
the
"EARLY REFLECTION" selector.
It is used to
indicate if the E/R value read from a memory
is larger
than,
smaller
than,
or equal
to the
current setting of the "EARLY REFLECTION"
selector
underneath
it.
(b EARLY REFLECTION Level Control
Press the "EDIT" key in the upper right hand
corner
of the panel
before using
this level
control.
Then adjust
it until
the LED in the
center of the indicator above
is lit.
After
that,
it can be adjusted.
It controls
the
output
level
of the early reflections
which
are then mixed with the "DIRECT" sound and
"REVERBERATION"
outputs;
the result of which
is controlled by the "MASTER"
level control
in
the lower right hand corner
of the panel.
16
Advertisement
