Advertisement
17
(SECTION IH)
REV. MODE
о
0 dB
REVERBERATION
(D REV.MODE
(Reverberation
Mode Setting)
keys
One of these keys can be set as standard
for
reverberation
output:
1 - SHD
(Super High Density)
2 - HD/HID
(High Desity/High
Initial
Diffusion )
3 - HD/LID
(High Density/ Low Initial
Diffusion )
4 - MD
(Medium Density)
5 - MLD
(Medium LOW Density)
6 - LD
(Low Density)
7 - SLD
(Super Low Density )
8 - ESD
(Equally Spaced Diffusion)
Press
the "EDIT"
key in the upper right hand
corner
of the panel
before using
these keys.
Press the "REV" key of the "DISPLAY" group of
keys
in the upper
left hand corner
of the
panel,
and the LCD will
show
the mode under
selection.
@ HIGH Indicator
This
is the set of three LEDs above
the
"HIGH" selector.
It is used to indicate if
the high range reverberation
time value read
from a memory
is larger
than,
smaller
than,
or
equal
to the current
setting of the "HIGH"
selector
underneath
it.
(9 HIGH (High Range Reverberation Time)
Selector
Press the "EDIT" key in the upper right hand
corner
of the panel
before using
this selec-
tor.
Then adjust
it until
the LED in the
center of the indicator
above
is lit.
After
that,
it can be adjusted.
Settings
can
be made in a range of 1] settings from -5 to
+5.
The high range reverberation
time
(later
reverberation
time)
settings
are
in reference
to those of the mid-low range.
(0 MID-HI Indicator
This
is the set of three LEDs above
the "MID-
HI" selector.
It is used to indicate if the
mid-high
range reverberation
time value read
from a memory
is larger
than,
smaller
than,
or
equal to the current setting of the "MID-HI"
selector
underneath
it.
Advertisement
