Advertisement
9. INPUT FILTER SELECTION
(D Press the "F/C" display key (see SECTION
I).
The LCD will display the present
cutoff
and crossover
frequency
status.
Example
FILTER
&
CROSSOVER
This display shows
that the
cutoff is for 8 kHz and above;
the "8K" LPF key has been
pressed.
a
a
ыры
@ Use one of the "50, 100, 200, or 400" HPF keys to cut off lower bands.
When pressed,
the LED of the key will
light up,
and the LCD graphical
display will change
accordingly.
By pressing
a lit key,
output can be sent
through.
(9 To cut off higher bands,
press one of the "АК, 6K, 8K, or 10K" keys.
When pressed,
the LED of the key will light up,
and the LCD graphical
display will change
accordingly.
By pressing a lit key,
output can be sent
through.
6. ADJUSTMENT
OF REVERBERATION
TIME
(D Press the "R/T" function key.
The LED of the key will light up.
@ Press one of the display keys: "W/F, R/T, RATIO"
to specify what display you
want;
and the LCD will change graphical
display appropriately.
Example
(R/T Mode)
- мч — ac
П
r3 ісу
Іі
ma am
к-ЕП алады
а
ТІПТІ
аны
4
4
р
MNT
e CI yum
Г
ei
aT mu
In this display,
R/T has been set at 4 seconds.
(@@ Use the ten-key numerical
pad to specify
the desired
reverberation
time.
Тһе
specified value will blink on the "REV. TIME" display.
At this time,
the "UP" and
"DOWN"
keys can be used
to alter
the data.
If these keys are used,
there
is no need
for the next step (4).
@ Press the "ENTER" key.
The "REV TIME" display will stop blinking,
and the displayed
data will
be set,
and the LCD will change
the graphical
display accordingly.
26
Advertisement
