Table of Contents
Advertisement
Clutch
NOTE: The clutch assembly
(55)
includes the armature
4.
Tap lightly on the back of the drive housing
(77) with
placed together so they wear evenly.
(55a) and rotor (55b). The armature and rotor must be re-
clutch housing (61). Pull the assembly away; the ar-
a plastic mallet to loosen the assembly (D) from the
NOTE: If the pinion assembly (138) is not yet separated
mature (55a) will come with it.
from the clutch housing, follow Steps 1 to 4. Otherwise,
start at Step
5.
5.
Remove
the
armature
from the pinion shaft.
1.
2.
3 .
Follow the Pressure Relief Procedure Warning on
Daae 7.
6.
Remove
the
four
socket head camcrews (157) and
. -
lockwashers (156). Install two oi the screws in the
Disconnect the hose
(133) from the displacement threaded holes
in the rotor (55b). Altematelv tiahten
~,
pump.
the
screws
until
the
rotor
comes
off. See F&.
i o .
Remove the bottom
two
screws (67) from the clutch
housing (61) and then remove the remaining three
7. Skip ahead to Reassembly, page 39, Step 6, or con-
screws (67).
tinue
on
the
next
page.
Fig.
40
USE A STEERING WHEEL
PULLER
TO
REMOVE
ROTOR
Q X 4 A
34
308-082
Advertisement
Table of Contents
