Table of Contents
Advertisement
Positioning the Gun Arm Assembly
Mount Guns on the Engine Side of the Cart
7. Install the guns. Note which gun and position on
the
1. For both guns, disengage the trigger cable and en-
dual gun selector each of the cables (1 and 402)
gage the trigger safety latch. See page 22.
goes. Route the hoses and cables to prevent kinking.
Position the spray tip guards. Disengage the gun trig-
2.
Loosen the gun holder Knobs
(93)
and remove the
ger safety latches. Engage the trigger cables.
gun. Lay
the
guns
out
of
the
way.
Setup for Spraying Arcs
3.
Remove the knobs (E)
on both carnage clamps
1. Disengage the trigger cable (1) and engage the gun
(9.D); the carriage bar (4) and extension clamps (A)
trigger safety latch. See page 21.
will drop down. See Fig. 15 DETAIL A.
2. Loosen the arm clamp
(6)
and rotate the arm (A)
4. Lift the front tire and rotate the carriage bar
180"
un-
back near the rear tireand then position the arm so
the spray tip guard aligns with the back axle of the
unit. Retighten the clamp.
der the cart and to the other side of it.
5. Position the carnage bar below the carriage clamps
3. Extend the carriage bar
(4)
or second gun bar (404)
(B,D). Align the holes
in
the top of the extension
clamps (A) with the holes in the carriage bar clamps
so you can easily watch the line you are painting and
also to avoid running over the paint line. See page
and install
the
knobs (E). See Fig. 15 DETAIL A.
17.
ioosen
the post/arm clamps
and
the guns
4. Adjust the vertical and horizontal position
of the gun.
forward.
Retighten
the
clamps.
5.
Spray
the
arc
from
the
outside.
Fig. 16
Adjust Simultaneous Gun Triggering
To reduce the risk of a fluid injection injury, always
engage the guns' trigger safely latch before moving
disengage the trigger cable to the gun (s) and
or adiustina the auns or aun arms.
1. Align the front of the guns by adjusting the gun arms.
See page
17.
10
308-082
2.
3.
Position the dual gun selector to trigger both guns.
See
page
21.
Start the sprayer, using water, or spray
on card-
board. See page
13.
Trigger the guns to see if the
lines begin at the same time and place.
It
one oun t
m before the other
w,
reduce the
cable tension of
the
gun that triggers first. See Ad-
just the trigger cable
tension
on page
22.
If one line starts in front of the othe
tion of the guns. See page 17.
r.
adjust the posi-
Trigger the guns to recheck the adjustments.
Advertisement
Table of Contents
