Clutch - Graco GM 5000 Instructions And Parts List

Clutch
NOTE: The clutch assembly
(55)
includes the armature
4.
Tap lightly on the back of the bearing housing (77)
redaced toaether so thev wear evenlv.
(55a) and rotor (55b). The armature and rotor must be with a plastic mallet to loosen the assembly (0) from
the clutch housina (61
),
Pull the assemblyaway; the
I
NOTE: If the pinion assembly (138) is not yet separated
from the clutch housing, follow Steps
1
to
4.
Otherwise,
start at Step
5. 5.
Remove the armature from the pinion shaft.
- . .
armature (55a) will come with it.
1. Follow the Pressure Relief Procedure Warning on
" a m 0
A
6. Remove the four socket head capscrews (157) and
rut)-
-.
2.
Disconnect the hose (133) from the displacement
lockwashers (156). Install
two
of
the screws in the
threaded holes in the rotor (55b). Alternateiytighten
the screws until the rotor comes
off.
See Fig. 38.
3.
Remove the bottom
two
screws (67) from the clutch
pump.
housing (61) and then remove the remaining three 7. Skip ahead to Reassembly, page 39, Step 6, or
screws (67).
continue on the next page.
A
Torque Io 7 fl-lb
(9.5 N.m)
A
Pinion shaft
A
Threaded
holes
133
Fig. 38
34
308-105