Reassembly - Graco LineLazer GM 3500 Instructions-Parts List Manual

Reassembly
1. Install the clutch housing (bl), capscrews (156)
and lockwashers (157) on the engine. See Fig. 46.
2. Install the engine shaft key (66). See Fig. 46.
3. Install the clamp (68) onto the engine shafi (A).
Maintain the 1.41 in.
+/-
0.01 (35.8 mm) dimension
shown in Fig. 47.
To check the dimension, place a rigid, straight steel
bar
(E)
across the face of the clutch housing (61).
distance between the inside of the bar and the face
Use
an accurate measuring device to measure the
of the clamp. Adjust the clamp as necessary. Toque
the two screws (60) to 125 iti-ib (14 N.m).
4. Connect the wires of the harness (58) to the screws
(57) in both places on the field. Pull the plastic caps
wires of the hamess (58) through the slot in the clutch
(C) up and snap them over the screws. Guide the
housing. Slide the field (70) into the clutch. Align the
setscrew chamfers in the field and the clutch housing
(61). Tighten the setscrews (62) oppositely and
evenly, to 25 in-lb (2.8 N.m). See Fig. 46.
A
to 25 in-lb (2.8 N.m)
Toque oppositely and
evenly
A
"
Connect wiring hamess (58) here before
slldlng field (70) into housing (61)
A
Toque to 125 l d b
(14
N.m)
A
Face of
housing
A
1.41" (35.8 mm)
A
Toque to 125 i d b
(14 N.m)
SIDE CUTAWAY VIEW
OF
CLUTCH HOUSING
Fig.
47
W M
36 306-082