User Controller - Mira Platinum Installation And User Manual

Installation: User Controller
1
Suitable for solid, dry-lined, stud partition, shower cubicle or laminated panel walls.
The user controller should be fixed to the wall at a convenient height for all the family.
It should be positioned so that water does not spray over it when the showerhead is
held on the slide bar.
Important! Make sure the Bluetooth signal has been tested between user
controller and digital mixing valve before permanently fixing to wall. See section
'Position and Signal Test' on page 23.
2
Mount the cradle on flat surface and mark the position for cradle holes.
Important! Ensure arrow on the cradle is oriented vertical as shown below.
Drill the fixing holes and fit the wall plugs. DO NOT drill through the cradle / backplate.
Caution! Avoid drilling through buried cables or pipes.
Make sure surface is clean and dry. Fix the cradle to finished wall surface.
Note: Use silicone sealant around wall fixing screws to prevent water ingress.
3
Hook the user controller on top of the
cradle and push into place.
Warning! This appliance contains
magnets. Users fitted with a heart
pacemaker or ICD should follow
their normal safety precautions
for products that contain magnets.
The magnets are located in the User
Controller and Cradle. There are no
magnets in the showerhead.
Note:
It is recommended to charge the
controller prior to installation.
4
Press the Mira showers logo to wake
up the user controller and check that
the connection with the valve is still
in place.
Note: To release the user controller, ensure
there is no water present and remove the
controller by lifting the bottom section from
the cradle.
Wa r n i n g! K n o c k i n g
t h e c o n t r o l l e r f r o m
the cradle may result
in the product being
inoperable. This is not
covered under warranty.
4 1
42