Mira Platinum Installation And User Manual page 50

Setting
Maximum Flow
Minimum Flow
Maximum
Temperature
Warm-up
Display Brightness
Display Mode
Start/Stop
Hot Water Low
Warning
Battery Level
Signal Level
Forget Valve
Add device
De-register System Disconnects valve from the Internet
Re-start Valve
Factory Reset
Re-commission
About
Exit
Caution! The MENU system for settings can only be accessed when the shower is
in the OFF state.
Note: Some menu items may not be displayed dependent on how the system is configured.
Note: If active, Warm-up mode can be overridden by pressing the required outlet buttons
three times when starting.
Description
Sets maximum flow rate
Sets minimum flow rate
Maximum temperature setpoint
Enables warm-up and delayed start
Set display brightness
Sets screen illumination time
Sets press requirement to start the
shower
Controls whether the "incoming
temperature too low" is reported.
Displays battery level
Displays the current BLE signal level
Un-pairs user controller from valve
Add bluetooth device to shower
Restarts valve and user controller
Factory resets valve and user controller
Re-starts the LP commissioning
process. See page 44.
Displays Valve, User Controller software
and Bluetooth software version number
Returns to the main menu.
Variables
High pressure valve - 4-16 lpm.
See page 13.
Pumped for gravity valve -
6-16 lpm. See page 14.
High pressure valve - 4-16 lpm.
See page 13.
Pumped for Gravity valve -
6-16 lpm. See page 14.
30° - 48°
On/Off
Low / Medium / High
Eco / Normal / Extended / Full
Double press/Single press
Enabled / Disabled
-
-
-
-
-
-
Confirm
-
-
-
50