Installation: User Controller
1
Position the installation template (supplied) at the position on the wall where you
intend to install the Controller.
Make sure that the template is level and mark the positions of the fixing holes on the wall.
2
For solid walls drill the fixing holes for the backplate with a 6mm drill and insert the
wall plugs (supplied). For other types of wall structure alternative fixings may be
required (not supplied).
Note: The Controller must be installed on a flat and even wall surface avoiding
any grout lines.
Using a suitable hole saw, drill the hole for the Controller cable as per the dimensions
given. Route the cable from the digital valve through the wall.
ø
6 mm
DO NOT drill into buried pipes.
ø
29 - 30 mm
DO NOT drill into buried cables.
43