Wireless Controller - Mira Vision Owner's Installation Manual

Wireless Controller

Suitable for solid, dry-lined, stud partition, shower cubicle or laminated panel walls.
The Wireless Controller should be fixed to the wall at a convenient height for all
the family. It should be positioned so that water does not spray over it when the
Showerhead is held on the Slide Bar.
Important! Make sure wireless signal has been tested between Wireless
Controller and Digital Mixer Valve before permanently fixing to wall. See section
'INSTALLATION - Digital Mixer Valve: Position and Signal Test'.
Mark position for backplate holes.
Mount backplate on flat surface (e.g.
Centre of tile).
Drill and plug holes.
Caution! Avoid drilling through
buried cables or pipes.
Make sure surface is clean and dry.
Fix backplate to finished wall surface.
Turn controller over and remove
the battery cover by loosening the 4
screws with a pozi drive screwdriver.
Note! The screws remain attached
to the battery lid.
Only fit new batteries of same make
and type. Do not use rechargeable
batteries. Replace all three batteries
at the same time.
Secure battery cover.
Hook Controller on top of backplate
and push firmly until Controller
"clicks" back into place.
31
1184347-W2-G