What You Need to Get Started
NI CB-2162 User Guide
LED ..................................................................................................17
Prototyping Area ..............................................................................17
Traces ...............................................................................................17
Power................................................................................................17
Physical.............................................................................................17
Technical Support Resources ..................................................................19
NI Web Support................................................................................19
Worldwide Support ..........................................................................19
To set up and use the NI CB-2162, you need the following items:
❑
SHC68-C68-D2 cable assembly
❑
Compatible NI digital waveform generator/analyzer, installed in a PXI
or CompactPCI chassis
You also may need the following optional items:
❑
Resistors and 10-pin single-inline packaged resistor networks for
pull-up/pull-down and series termination.
❑
The NI CB-2162 ships populated with a 0 Ω resistor. A 50 Ω resistor
also is included for optional STROBE series termination.
❑
30-gauge wire
❑
Wire-wrap tool
❑
1x2 header receptacle(s)
❑
DC power supply for the prototyping area
❑
The documentation included with the digital waveform
generator/analyzer module and the NI-HSDIO driver software
2
ni.com