What You Need To Get Started - National Instruments SCB-100 Installation Manual

1. Quick Reference Label
2. Top Cover
3. 100-Pin Connector Screw
4. Grounding Screw
5. 100-Pin I/O Connector

What You Need to Get Started

• SCB-100 100-pin shielded connector block and quick reference label
• 100-pin DAQ device and device documentation
• SH100100 cable (part number 182853-0x) for E Series/MIO devices or SH100-100-F
cable (part number 185095-0x) for DIO/TIO Series devices
• Phillips #1 and #2 screwdrivers
• 14-26 AWG wire
• Wire cutters
• Wire insulation strippers
• 1/8 in. flathead screwdriver
• Soldering iron and solder (optional)
• Long-nose pliers (optional)
• Resistors and capacitors specific to your application (optional)
Attaching the Quick Reference Label
A quick reference label is included in the SCB-100 100-pin shielded connector block kit to
show switch configurations and define screw terminal pinouts for E Series devices. Place the
label on the inside of the top cover.
2 | ni.com | NI SCB-100 Installation Guide and Specifications
Figure 1. SCB-100 Connector Block
9
8
7
1
2
4
5
6
6. Base
7. Strain-Relief Hardware
8. Strain-Relief Screws
9. SCB-100 Board Assembly
3