Making A Wire-Wrap Connection - National Instruments CB-2162 User Manual

Making a Wire-Wrap Connection

© National Instruments Corporation
Make connections from the appropriate 1x1 header with a standard
wire-wrap tool and 30-gauge or similar wire. Strip the wire and insert it into
the receptacle end of the wire-wrap tool. Place the wire-wrap tool over the
appropriate header pair pin, and twist the tool around the header post. You
then can make connections to the device under test (DUT) as defined by the
device manufacturer. Connect the DIO channel and ground header pins for
each channel being used.
Figure 6 provides an illustration for making a wire-wrap connection.
1 Wire-Wrap Tool
2 Stripped Wire
1
3 Header Pin Receptacle
Figure 6. Wire-Wrap Connections
11
2
3
NI CB-2162 User Guide