Connecting Power; Prototyping Circuits; Replacing Components - National Instruments CB-2162 User Manual

Connecting Power

Caution NI is not liable for any device damage or personal injury resulting from improper
connections that exceed the maximum specifications of the NI CB-2162.

Prototyping Circuits

Replacing Components

NI CB-2162 User Guide
To provide power to the prototyping area, connect V
supply to J3 (red terminal) and ground to J4 (black terminal). Refer to the
Specifications section for the acceptable voltage ranges.
The green power LED is lit when a positive voltage is applied to the
NI CB-2162. However, if negative voltage is applied, the Power LED does
not light. The power connectors and LED for the prototyping area are
labeled in Figure 1.
The prototyping area of the NI CB-2162 consists of 304 through-hole
solder pads—208 isolated pads for component mounting and wire
connections, 48 pads connected to V
ground—and space for gluing surface-mount components.
Refer to the Specifications
generator/analyzer modules specifications for information on the voltage
limitations on circuits created in the prototyping area.
The NI CB-2162 does not use replaceable fuses. If you need to replace the
LED, choose a replacement that meets the specifications described in the
Specifications section.
, and 48 pads connected to
CC
section and to the NI digital waveform
16
from a DC power
CC
ni.com