Advertisement
Contents
Connections
Dirac Live can not be selected.
This cannot be selected when you have not perforned Dirac Live Room Correction. "Dirac Live Setup" (v p. 252)
0
This cannot be selected when using the headphone.
0
Dirac Live cannot be used when the "Speaker Layout" is changed to different settings from the settings that were used when Dirac Live Room
0
Correction was performed.
"Restorer" cannot be selected.
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of multichannel signals such as Dolby Digital or DTS
0
surround, "Restorer" cannot be used. (v p. 193)
Switch to a sound mode other than "Direct" or "Pure Direct". (v p. 143)
0
No audio is output from PRE OUT or speakers for ZONE2/ZONE3.
In ZONE2/ZONE3, the audio can be played back when signals input from digital connectors (OPTICAL/COAXIAL) are in 2ch PCM format.
0
In ZONE2, the audio can be played back when signals input from the HDMI connector are in 2ch PCM format. To play back the audio in ZONE2
0
irrespective of the input signal format, set "HDMI Audio" in the menu to "PCM". Depending on the played back device, the audio may not be played back
even with this setting. In that case, set the audio format to "PCM (2ch)" on the played back device. (v p. 268)
When listening to audio from a Bluetooth device in ZONE2/ZONE3, remove any obstructions between the Bluetooth device and this unit and use it
0
within a range of about 98.4 ft/30 m.
Sound mode settings are not available when using Bluetooth headphones. Audio menu settings are also not available.
This unit cannot change sound mode or audio menu settings for audio output to Bluetooth headphones.
0
Front panel
Display
Playback
Settings
289
Rear panel
Tips
Remote
Index
Appendix
Advertisement
