Advertisement
Contents
Connections
Crossovers
Set in accordance with the lower limit frequency of the base frequencies
that can be played back through each speaker. See the speaker manual
for information concerning speaker crossover frequency.
o Set the crossover frequency
Full Range:
40 Hz / 60 Hz / 80 Hz /
90 Hz / 100 Hz / 110 Hz /
120 Hz / 150 Hz / 180 Hz /
200 Hz / 250 Hz
(Default: 80 Hz)
0 The default crossover frequency is "80 Hz", which will work best with the
widest variety of speakers. We recommend setting to a higher frequency that
the crossover frequency when small speakers are used. For example, set to
"250 Hz" when the frequency range of the speakers is 250 Hz – 20 kHz.
0 Sound below the crossover frequency is cut off from the output of the
speakers. This cut off bass frequency is output from the subwoofer or front
speakers.
0 The "Front" is automatically set to "Full Range" when "Subwoofers" is set to
"No" in the "Speaker Layout".
0 Each speaker can be set to "Full Range" only when the Front is set to "Full
Range".
0 The audio settings in "IMAX Audio Settings" are applied during IMAX
playback. (v p. 188)
Front panel
Display
Playback
Select "Full Range" to set the speaker to
play full-range audio.
Selects the crossover point to send the
low frequency sound to the subwoofer.
Rear panel
Settings
Speaker Preset
Two speaker settings can be saved to suit the environments where you
use your speakers.
For example, in some cases the characteristics of a room change
depending on whether a screen is used. By saving two different presets,
you can easily switch between the equalizer and speaker settings for each
situation that were measured with an Audyssey
Presets also make it easy to switch between the sound effects of an
Audyssey Setup and those of Dirac Live.
If you want to use a preset, select the preset you want to use and then
configure settings such as Audyssey
Correction
and speaker settings to save those settings to the selected
z
preset.
z When exporting measurement results from Dirac Live Software to this unit for the
first time, the settings are automatically saved in "Speaker Preset 2".
Speaker Preset 1
(Default):
Speaker Preset 2:
244
Remote
Tips
Appendix
®
Setup.
®
Setup, Dirac Live Room
Saves the settings to Preset 1.
Saves the settings to Preset 2.
Index
Advertisement
