Advertisement
Contents
Connections
o Front/Center/Surround/Surround Back/Front
Wide
Set the correct audio output terminals for your speaker system.
n Configuration
Select whether or not each speaker exists. For Surround Back
speakers, select the number of speakers to be used.
[Front/Center/Surround/Front Wide]
Yes
(Default):
No:
[Surround Back]
2 spkrs
(Default):
1 spkr:
No:
0 "Front" is fixed as "Yes" as it is required for playback.
0 When "Surround" is set to "No", "Surround Back" and "Front Wide" settings are
automatically set to "No".
Front panel
Display
Playback
The selected speakers will be used.
The selected speakers will not be used.
Two Surround Back speakers will be
used.
Only one Surround Back speaker will be
used. When you select this setting,
connect to the SURROUND BACK L
terminal.
Surround Back speakers will not be used.
Rear panel
Settings
n Connection
Select the output terminals for audio from the speakers.
Spkr + Pre-out
(Default):
Pre-out Only:
0 When "Amp Assign" is set to "Preamplifier", the "Connection" setting of all
speakers will be fixed as "Pre-out Only".
0 When "Amp Assign" is set to "13.1ch" and 13 channels of speakers are used,
at least one of the channels assigned to the Front, Height 3 or Front Wide
must be set to "Pre-out Only".
228
Remote
Tips
Appendix
Speaker and pre-out outputs are active.
Pre-out outputs are active. Speaker
outputs are disconnected for enhanced
audio quality using only the pre-out
terminals.
Index
Advertisement
