Advertisement
Contents
Connections
Subwoofer Output
Selects which low frequency signals are sent to the subwoofer outputs.
o Subwoofer Output
LFE
(Default):
LFE + Main:
o Bass Extraction LPF
Selects the low-pass filter point for the full-range speaker to copy the
low frequency signal to subwoofer.
40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz / 120 Hz / 150 Hz /
180 Hz / 200 Hz / 250 Hz (Default: 80 Hz)
Front panel
Display
Playback
The subwoofer outputs receive the LFE
track, plus any redirected bass from
speakers with crossovers set. Use this
setting as the default for home theater
bass management in a typical room.
The subwoofer outputs receive the LFE
track, plus redirected bass, and a copy of
the low frequency signals from all full-
range speakers.
Rear panel
Settings
0 "Subwoofer Output" can be set when "Speaker Layout" - "Subwoofers" in the
menu is set to other than "No". (v p. 235)
0 Play music or a movie source and select the mode offering the strongest bass.
0 If "Crossovers" - "Front" and "Center" are set to "Full Range", and "Subwoofer
Output" is set to "LFE", no sound may be output from the subwoofers,
depending on the input signal or selected sound mode. (v p. 244)
Select "LFE + Main" if you want the bass signals to always be produced from
the subwoofer.
0 "Bass Extraction LPF" can only be set for channels with "Crossovers" set to
"Full Range".
0 The audio settings in "IMAX Audio Settings" are applied during IMAX
playback. (v p. 188)
246
Remote
Tips
Appendix
Index
Advertisement
