Advertisement
Contents
Connections
o Dolby Speaker Setup
Set the distance between the Dolby Atmos Enabled speaker and the
ceiling.
3.0 ft - 10.8 ft / 0.90 m - 3.30 m (Default: 5.9 ft / 1.80 m)
0 This can be set when "Front Dolby", "Surround Dolby" or "Back Dolby" is set to
use in "Speaker Layout". (v p. 226)
0 Cannot be set when Dirac Live are being used. (v p. 198)
o Set Defaults
The "Distances" settings are returned to the default settings.
Front panel
Display
Playback
Settings
Levels
Set the volume of the test tone to be the same at the listening position
when it is output from each speaker.
"Levels" values for each filter are stored independently in Dirac Live Room
Correction.
o Test Tone Start
A test tone is output from the selected speaker.
While listening to the test tone, adjust the volume output from the
selected speaker.
–12.0 dB – +12.0 dB (Default : 0.0 dB)
0 The set "Levels" are reflected in all sound modes.
0 If you want to adjust the channel levels for each input source, set these in
"Channel Level Adjust" in the options menu. (v p. 134)
0 When headphones are connected to the PHONES connector on this unit, you
cannot set "Levels".
o Set Defaults
The "Levels" settings are returned to the default settings.
243
Rear panel
Tips
Remote
Index
Appendix
Advertisement
