Operating
Setting the behaviour on DMX
control failure
2bright Pint TW200 IP MK II
26
LED PAR
1.
Press [MENU] and then [UP] or [DOWN] repeatedly until the display shows 'Settings' .
Confirm with [ENTER].
2.
Press [UP] or [DOWN] repeatedly until the display shows 'DMX Fail' . Confirm with
[ENTER].
3.
Use [UP] or [DOWN] to select either 'Hold' , 'Blackout' or 'Emergency Light' to make the
setting to be used when the DMX controller fails.
The following sub menus are available:
Menu level 3
'Hold'
'Blackout'
'ManualMode'
4.
Press [ENTER] to accept the selection.
Function
The last received signal is held.
The spotlight is turned off.
The device calls up the values set in the 'Stand Alone' menu.