Display Test Mode.66 - Star Trac 4500 Owner's Manual

The following keys are available in Motor Test Mode:
INCLINE
Keys: Adjust voltage to incline motor to make running deck incline up
and down in increments of 1%. Keys will repeat if held.
DANGER: Do not adjust the voltage below the lowest allowable ELMAX=25 (0.49 volts) or
above the highest allowable ELZERO=242 (4.75 volts), as safety features are turned off in Motor
Test Mode, and mechanical damage may ensue.
+ | — | SPEED
Keys: Adjust PWM duty cycle to make motor speed go up and down in
increments of 0.1 mph (UNITS^English) or 0.1 km/hr (UNITS=Metric).
Heart Rate Key: Starts automatic calibration of MIN PWM, 1/2 MAX, and MAX PWM
for MIN SPD and MAX SPD range. Calibration lasts less than 3 minutes and will move the
running belt. Press
[STOP]
when running belt has stopped, to save calibration.
START
Key: Starts bum-in (continuous operation of running belt and incline screws) using
one of the Program Selections at maximum speed. Press
|ST0Pl
to stop bum-in.
STOP
Key: Exits Motor Test Mode and enters Operating Mode. Stops bum-in.
Number/Program Select Key: Selects letter Z or M following Elevation (Incline) data
numeral to signify that numeral may be saved as ELZERO or ELMAX, respectively.
To leave Motor Test Mode and enter Operating Mode, press and release
[STOPl-
Display Test Mode
Display Test Mode allows you to test the light-emitting diodes (LEDs), 15-segment displays, and
watchdog timer of the Display Control Panel by way of its own controls and displays. It also
allows you to see the EPROM version. To enter Display Test Mode:
• Enter Manager Settings (or Maintenance Settings).
• Press and
hold 0, Q,
and |
START!
together (or
0, Q,
and
ISTARTl
together).
• Release |£] (or B>-
66
STAR TRAC 4500 TREADMILL Owner's Manual