Star Trac 4500 Owner's Manual page 61

service), the start-up display will scroll REWAX BELT. This is a reminder to have your maintenance
or service provider perform this 5 minute belt rewaxing at your convenience. (Immediate service
is not required). Wax is included in the treadmill.
TOOLS & MATERIALS
1 Bottle of Wax Powder
1 Clean Towel
1 Paint Stick or Ruler
Diluted All-purpose Cleaner (409), or Bristle Brush
PROCEDURE
Apply wax powder while belt & deck are still warm
(5 minutes minimum use) for optimum benefit.
1. CAUTION: POWER OFF AND UNPLUG THE TREADMILL.
2. CLEAN DECK & BELT:
A. Using the stick or ruler, slide a towel under the middle of the belt from one side of the
frame to the other.
B. Hold the edges of the towel; pull to the tailroller; pull to the headroller; then pull the belt
down to wipe the remaining belt. TIP: Fold the dirty towel & shake into trash.
3. LIFT BELT: Lift the left side (facing display) of the belt, about 12 inches down from the
cover (see figure). Hold the belt up to elevate the belt from the deck.
4. SPREAD WAX: Flip the nozzle on the cap of the wax bottle. Point the nozzle at the deck. Be
sure that the bottle is tilted at a downward angle. Squeeze the wax bottle twice between the
running belt and the deck. TIP: Gently shake bottle between each squeeze.
5. Repeat steps 3 & 4, about 18 inches from the end of the deck.
6. Repeat steps 3 through 5, on the right side of the belt/deck.
7. WALK: Plug in treadmill. Power ON the treadmill. Start the treadmill at 1 mph and walk on all
sections of the belt and deck for 1 minute to ensure the wax has been evenly distributed and
worked-in properly.
8. CLEANUP: Power OFF the treadmill. Remove any excess wax with diluted cleaner (409)
and towel. TIP: Blow away extra wax first (like dust), then wipe.
9. DISPLAY UPDATE: Update the LST DCK service mileage to remove the REWAX BELT
message.
A. Power ON the treadmill.
B. Enter MAINTENANCE SETTINGS (see Chapter 7)
C. Press the INCLINE DOWN key until the display window reads LST DCK.
D. Press the HEART key to automatically enter the present distance.
E. Press the START key to enter and update the dislay.
F. Press the STOP key to exit MAINTENANCE SETTING.
5G STAR TRAC4500 TREADMILL Owner's Manual