4.10 Installing The Unit On Site - Spartherm Premium Assembly And Operating Manual

4.10 Installing the unit on site

the brickwork for the convection chamber and the lining of
the unit is installed on site. to ensure problem-free operation,
absolutely adhere to the requirements listed in this chapter.
the following images of installation situations are used as
examples for all units.
With non-flammable construction materials
4.10 / 1
A
B
C
A insulation of the convection chamber
B Wall collar
C Flue gas pipe (connection piece)
D Air supply grating (hot air outlet)
E Convection chamber
F Fireplace lining made from non-flammable construction
material
G support frame with insulation strips
H Circulating air grating (cold air supply)
I
Combustion air line (optional)
For information on the insulating material thickness, refer to
1
the separate document "technical data".
500 mm distance between top edge and ceiling.
2
D
E
F
G
H
I
1
2
Assembly and operating manual | Premium & Lean | 06.2023 | en
4.10 / 2
A
B
C
D
A insulation of the convection chamber
B Wall collar
C insulated flue gas pipe (connection piece)
D Convection air housing (optional)
E Hot air outlet
F Convection chamber
G Air supply grating
3
H Hot air line
4
I insulation of the convection air housing
J Fireplace lining made from non-flammable construction
material
K support frame with insulation strips
L Circulating air grating (cold air supply)
M Combustion air line (optional)
1 For information on the insulating material thickness, refer to
the separate document "technical data".
if a convection air housing is used, all connections must be
2
connected to hot air lines.
500 mm distance between top edge and ceiling.
3
insulation required if temperatures above 85 °C are possible
4
(depending on the specific installation situation).
insulation with shape-retaining mineral wool,
5
min. 30 mm thick.
E
F
G
H
I
J
K
L
M
1
2
5
31