Table of Contents
Advertisement
4.6
Unpacking the unit
4 Check the packaging for damage.
4 remove the packaging.
4 undo the screws of the transport securing mechanism on
the pallet.
4 lift the unit off the pallet.
4 Check the scope of delivery for completeness and ensure
that it is not damaged.
6 "2.7 scope of delivery" (page 10).
in the event of damage or incompleteness:
4 Contact the manufacturer.
if the packaging is no longer required:
4 properly dispose of the packaging material.
6 "9.1 disposing of the packaging" (page 53).
When delivered, the radiation protection plate is attached to
the unit in the transport position. installation in the assembly
position is only performed in the corresponding assembly step.
4.6 / 1
4 detach the radiation protection plate from the unit.
4.7
Adjusting the counterweight (optional)
this step is required if the self-closing door function is used.
6 "2.4 protective devices" (page 6).
Conversion to a self-closing firebox door is performed by
removing weighted pieces. the counterweight is set correctly,
when the firebox door closes slowly and with a constant speed.
4.7 / 1
4 remove the weight shaft lining.
Assembly and operating manual | Premium & Lean | 06.2023 | en
27
Advertisement
Table of Contents
